[sword-devel] osis2mod output (Bisaya-Inunhan NT)
jmarsden at fastmail.fm
Wed Apr 29 09:58:59 MST 2009
Wearing my shiny new SWORD module creator hat:
My rough draft (sans footnotes and titles) OSIS conversion of the
Bisaya-Inunhan NT is valid OSIS 2.1.1 per xmllint. However, I'm seeing
some output from osis2mod that I need help interpreting. Currently it says:
You are running osis2mod: $Rev: 2325 $
re-versified III John 1:15 as III John 1:13
Appending entry: Jude:
re-versified Revelation of John 12:18 as Revelation of John 12:16
Appending entry: Rev.13:
(1) Enhancement request #1: I do not know if these are informational,
warning, or error messages. Prefixing them with INFO: WARN: or ERROR:
would be really helpful in this regard.
(2) Enhancement request #2: osis2mod does not seem to exit with an exit
code that reflects the worst issue found during the run -- I'm seeing an
exit code of zero despite these messages.
(3) Enhancement request #3: If these messages could include a line
number from the original OSIS input file, or a line or two of it at the
point of the info/warning/error, that would really help.
NOTE: None of these are necessities for 1.6; just ideas for the future.
BOTTOM LINE: Is re-versifying these things "bad"? Do I need to get
osis2mod to run with no output before I can consider the module "clean"?
What is really going on here? Is there a Wiki page or other
documentation that explains these messages that I should have read?
More information about the sword-devel