[sword-devel] HowTo: create ztext module?

L.Allan-pbio paraclete at bibleinverse.org
Mon May 8 15:09:57 MST 2006

Thanks for the hints.

I build mod2zmod.exe and wrestled with it for a while, but didn't end 
up with anything that showed up in sword.exe 1.5.8 rc1.

What would the command line steps be to compress something like the 
WEB (currently rawtext)? Do you have to change the web.conf, and, if 
so, in what ways?

Also, there is a file mod2zmod2.cpp that refers to the non-existing 
ztext.h. Do you know anything about it?

Barry Drake wrote:
> Hi Lynn .........
> L.Allan-pbio wrote:
>> I'd appreciate a hint or two on how to create ztext modules.
> It's really simple.  You make a plaintext module and install it as a
> Sword module, then run the command line utility mod2zmod.  This can
> make a compressed module either with or without a cipherkey 
> depending on
> the parameters you pass.  Run mod2zmod without parameters to get the
> instructions.
> God bless,
> Barry
> -- From Barry Drake (The Revd) minister of the Netherfield United
> Reformed church, Nottingham see http://www.jesusinnetherfield.org.uk
> for our church homepages).
> Replies - b.drake at ntlworld.com
> _______________________________________________
> sword-devel mailing list: sword-devel at crosswire.org
> http://www.crosswire.org/mailman/listinfo/sword-devel
> Instructions to unsubscribe/change your settings at above page 

More information about the sword-devel mailing list