[sword-devel] Compiling Sword

DM Smith dmsmith555 at yahoo.com
Sun Jul 23 20:44:59 MST 2006


I first do:

Carefully read the output. It may tell you to concat a file. Don't  
remember exactly, but it is something like aclocal.m4.

Then run ./usrinst.sh which will run configure for you.

Hope this helps,

On Jul 23, 2006, at 11:18 PM, Moses Truong wrote:

> I'm trying to compile Sword from SVN following instructions from
> http://www.crosswire.org/sword/develop/biblecs/svn.jsp
> After checking out from https://crosswire.org/svn/sword/trunk (from  
> I think - I was using kdesvn)
> I tried to run ./configure - but the file does not exist.
> I tried to run ./usrinst.sh - but it gives same error = ./ 
> configure: No
> such file or directory.
> Can anyone suggest where I can find this ./configure?
> Thanks
> moses
> _______________________________________________
> sword-devel mailing list: sword-devel at crosswire.org
> http://www.crosswire.org/mailman/listinfo/sword-devel
> Instructions to unsubscribe/change your settings at above page

More information about the sword-devel mailing list